/* IQC program */
/* IC : ssd1306  8080 8bit */
/* Module : 0.68´ç 9632-COG */

  
void write_i(unsigned char ins)
{
	
   DC=0;
   CS=0;
   WR=1;
   P1=ins;       /*inst*/
   WR=0;
   WR=1;
   CS=1;
}

void write_d(unsigned char dat)
{ 
   DC=1;
   CS=0;
   WR=1;
   P1=dat;       /*data*/
   WR=0;
   WR=1;
   CS=1;
}


void delay(unsigned int i)							
{
   	while(i>0)
   	{
		i--;
   	}
}


                   
void  ssd1306()
{
       write_i(0xAE);    /*display off*/ 
      
       write_i(0x00);    /*set lower column address*/       
       write_i(0x11);    /*set higher column address*/       

       write_i(0x40);    /*set display start line*/ 
      
       write_i(0xB0);    /*set page address*/     
  
       write_i(0x81);    /*contract control*/
       write_i(0x60);    /*128*/  
     
       write_i(0xA1);    /*set segment remap*/ 
     
       write_i(0xA6);    /*normal / reverse*/  
     
       write_i(0xA8);    /*multiplex ratio*/
       write_i(0x1F);    /*duty = 1/64*/  
     
       write_i(0xC8);    /*Com scan direction*/   
    
       write_i(0xD3);    /*set display offset*/
       write_i(0x00);       

       write_i(0xD5);    /*set osc division*/
       write_i(0x80);          

       write_i(0xD9);    /*set pre-charge period*/
       write_i(0X1f);      
 
       write_i(0xDA);    /*set COM pins*/
       write_i(0x12);      
 
       write_i(0xdb);    /*set vcomh*/
       write_i(0x40);       

       write_i(0x8d);    /*set charge pump disable*/
       write_i(0x14);      
 
       write_i(0xAF);    /*display ON*/                     

}